Front&rear lighting system headlight taillight for 1/24 LOSI Micro-B 2WD Buggy RC Truck

Quantity:1 set
Voltage: 5V
Suitable for: 1/24 LOSI Micro-B 2WD Buggy RC Truck

Micro-B 2WD BUGGY is a special front and rear light set for remote control electric two-wheel drive off-road vehicles. The product is made of nylon shell and is strong and durable. For the installation method, refer to the red arrow in the detailed picture. Remove the front shock absorber fixing screws. Pass the headlight through the middle of the shock absorber. Then install the two screws under the shock absorber. Put the 1.4*12 screws for the car light through the two fixing holes of the headlight. Then use the silver aluminum spacer in the accessory bag to penetrate the screw protrusion. Then use long screws to fix the headlight on the shock absorber. Install the two screw holes on the shock absorber. To install the rear light, directly remove the two screws on the left and right below the rear spoiler. Then fix the rear light bracket to the removed screw position with the two 1.4*8 screws provided with the light. For wiring, directly unplug the original servo plug and plug it into the female plug of the light, and then plug the male plug of the light into the female plug from the servo. Turn it on and test whether the light is normal. Due to the tight space in the car, wiring must be done well. Refer to the complete vehicle wiring in Figure 5 for details. Except for the fixed position of the original female connector for the servo, it must not be moved. The female connector of the light must be in the front. Unplug the motor wire, pass the lamp wire through it from underneath, and then reinstall the motor plug. After that, use a tie to fix the female head of the light fitting, or you can use double-sided tape to fix it. Try to fix all the wires that do not need to be moved frequently. A mess may cause the car shell to not be installed in place.